Lockable Container with hidden key


This is a development of the previous lockable container, even uses the some of the same parts from the earlier design. This time however it has a slide out tray for storing the Key, primarily so it won’t get lost but also to add a little mystery as to where it is.

Access to the key by depressing the button on the side and the pulling out the tray holding the key from the front.

All parts are made from ABS with the exception of a short Ø1.5 mm or 1/16” diameter steel pin used as a pivot for the Sprung Latch used to hold the tray in place, this was necessary to stop the pivot breaking of if the Tray is pulled too strenuously.




Printer: Zortrax M200

Rafts: Yes

Supports: some

Resolution: 0.19

Infill: Medium


STL files can be downloaded here











Lockable-Container-with-Hidden-key-1.jpg Lockable-Container-with-Hidden-key-2.jpg Hidden-key 478.JPG Hidden-key 479.JPG Hidden-key 480.JPG Hidden-key 481.JPG Hidden-key 482.JPG Hidden-key 483.JPG Hidden-key 484.JPG Hidden-key 485.JPG Hidden-key 486.JPG Hidden-key 487.JPG Hidden-key 488.JPG Hidden-key 489.JPG Hidden-key 490.JPG Hidden-key 491.JPG